A-A-52148
CID Based Part Identification Number (PIN)
Manufacturer’s Name, Address, and Telephone Number
Supplier’s Name, Address, and Telephone Number (List Only if Different from Manufacturer)
Manufacturer’s Model and Serial Number
Government Approved Manual Number
Each plate shall be place so that it is readily visible to the operator during normal operating use and so as to not adversely use and so as to not adversely affect the life and utility of the steam table.
2.4 Metric products. Products manufactured to metric dimensions will be considered on an equal basis with those manufactured using inch-pound units, providing they fall within the tolerance specified using conversion tables contained in the latest revision of Federal Standard 376, and all other requirements of this document are met. If a product is manufactured to metric dimensions and those dimensions exceed the tolerances specified in the inch/pound units, a request should be made to the contracting officer to determine if the product is acceptable. The contracting officer has the option of accepting or rejecting the product.
2.5 Regulatory requirements. In accordance with Section 23.403 of the Federal Acquisition Regulations, the Government’s policy is to acquire items composed of the highest percentage of recovered materials practicable, consistent with maintaining a satisfactory level of competition without adversely affecting performance requirements or exposing the supplier’s employees to undue hazards from the recovered materials. The offeror/contractor is encouraged to use recovered materials in accordance with Public Law 94-580 to the maximum extent practicable. The term “recovered materials” means materials which have been collected or recovered from solid waste and reprocessed to become a source of raw materials as opposed to virgin raw materials. None of the above shall be interpreted to mean that the use of used or rebuilt products are allowed under this commercial item description unless otherwise specified.
2.6 Workmanship. The finished steam tables shall be complete, clean and free of fabrication marks, scratches, dents, sharp edges, sharp corners, burrs, slivers, or visible evidence of rust. Rivets when used, shall be tight and the rivet heads and peened ends shall be round and concentric and in full contact with the joint metal surfaces. There shall be no empty rivet holes. Welds shall be clean, continuous, sound, and free of flux, pits, buildups, undercuts, and shall be ground so as to blend with the adjacent surfaces. Spot welds shall be free from pits, burn throughs, and flashes.
3. QUALITY ASSURANCE
3.1 Contractor certification. The contractor shall certify that the product offered meets the salient characteristics of this description and except for those government unique requirements
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business