MIL-PRF-44466D
3.3.3 Dimensions. The unit shall have overall dimensions no greater than those shown on
Drawing No. 5-13-6900. The casing height shall vary in accordance with Type I or Type II
vechicle mounting application as shown on Drawing No. 5-13-6900.
3.3.4 Power cord. The power cord as shown on Drawing No. 5-13-6901 shall be designed
to interface with the electric supply receptacle as shown on Drawing No. 5-13-6900.
3.3.5 Electric supply receptacle. The electric supply receptacle, pins and polarizing key
location shall be as shown on Drawing No. 5-13-6900. The pin connections shall be Pin A
positive, Pin B negative, and Pin C no connection. National Stock Number (NSN) 5935-01-191-
4015 or equivalent shall be utilized to meet this requirement.
3.3.6 Mounting studs. The mounting studs shall be permanently attached and threaded,
positioned and dimensioned as shown on Drawing No. 5-13-6900.
3.3.7 Food contact zone. The surfaces of the main compartment and inner container shall be
nontoxic and resistant to cleaning agents used during current field practice for cleaning cooking
utensils.
3.4 Support or ownership requirements. The HWR shall satisfy the following support or
ownership requirements.
3.4.1 Reliability. The HWR shall demonstrate a mean time between essential mission failure
(MTBEMF) of at least 640 operational hours at a minimum confidence level of 80%.
3.4.2 Weight. The maximum net weight of the empty HWR shall be 20 pounds.
3.4.3 Maintainability. Routine maintenance and servicing of the HWR shall require only
standard hand tools. Maintenance and servicing shall be considered in the placement of
components and access panels.
3.4.3.1 Electrical wiring. Electrical wiring shall be arranged, supported, and marked to allow
identification with the wiring diagram.
3.4.4 Marking. Identification, instruction, and control plates shall be of corrosion-resistant
material permanently attached to the outside of the unit. Numbering and lettering shall be legible
and permanently inscribed and shall be no less than 1/16 inch in height. All plates shall have a
nonreflective surface.
3.4.4.1 Identification plate. The identification plate information shall include the
manufacturer's name, contract number and date, the Commercial and Government Entity (CAGE)
number and the technical manual number, if applicable, (see 6.2 and 6.5).
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business