A-A-50037B
2.4 Thermostats. The type I, size1 and 2, and type II, size 1 griddles shall be equipped with a minimum of two thermostats, and the type II, size 2, griddle shall be furnished with a minimum of three thermostats. A temperature dial indicating knob with temperature graduations not to exceed 250F in the operating temperature range of 2000F to 4500F shall be provided for each thermostat control.
2.5 Fuel system. The griddles shall be designed to operate on natural gas and on liquid petroleum gas (LPG) when converted by a separately furnished kit. The orifice hoods or spuds installed for natural gas shall be unpainted brass. Black color-coded orifice hoods or spuds to convert the unit to operate on LPG shall be furnished. A conversion kit and complete instructions to operate on LPG shall be furnished with each griddle. The type I, size 1, griddle shall have a minimum of two burners and have a total rating of 60,000 BTU/hr. minimum. The type I, size 2, and type II, size 1 griddles shall have a minimum of three burners, and the type II, size 2, shall have a minimum of six burners with each burner having a rating of 30,000 BTU/hr. The griddle shall be equipped with a continuous pilot, a pressure regulator, and an automatic ignition system. An American Gas Association (AGA) approved quick disconnect (socket and plug) conforming to ANSI Z21.41, and a 5 foot minimum flexible metal connector conforming to ANSI Z21.45 consisting of a male pipe thread fitting on one end and a union with female thread on the opposite end shall be provided with the griddle.
2.6 Standard compliance. The griddle shall comply with American National Standards Institute (ANSI) Z83.14 and NSF International Standard No. 4. The stand for the type II griddles shall comply with NSF International Standard No. 2.
2.7 Data nameplate (“Government unique” requirement). The griddles shall be furnished with a data nameplate in accordance with the applicable requirements of MIL-STD-130 except the requirements for: (a) Methods of applying, (b) Identification tags, (c) Information not required, and (d) Optional marking information shall not apply. The data nameplate shall be made of minimum 20 gauge corrosion-resisting metal and attached to the griddles by rivets, screws or welding, in such a manner as to meet the applicable NSF International sanitary requirements for this equipment. In addition to the marking requirements of ANSI Z83.14, the plate shall contain the following information which shall be stamped, engraved, or applied by photosensitive means:
Contract Number
National Stock Number
Procurement Instrument Identification Number
CID Based Part Identification Number (PIN)
BTU Rating
Manufacturer’s Name, Address, and Telephone Number
Supplier’s Name, Address, and Telephone Number (List only if different from Manufacturer)
Manufacturer’s Model and Serial Number
Government Approved Manual Number (see 5.2).
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business